LightInterface

Until now, it has been really difficult to do automatic light measurements of controllable light sources in multiple settings.
Viso LightInterface is a gamechanger: It enables you to set up a measurement sequence that tests your solution in multiple variables and levels.

LightInterface handles all contemporary wired protocols: DALI, DMX/RDM, and 0-10V. Simply connect LightInterface to your measurement PC and your fixture control terminals. The free Viso Light Inspector software automatically detects LightInterface, and allows you to set up your control sequence.

Both device definitions and control sequence configurations can be saved and reused. This allows you to test your controllable systems systematically, and save all results in one file.

Build your own control sequences in Viso Light Inspector software: No matter which protocol that you are working with, your can set up a specific sequence and save it as a template. 

You can regulate a single parameter or combinations of two parameters.

During measurement start up, chose your device and and the desired test sequence. Then the system will automatically run your normal measurement followed by the regulation seqeunce. Hence, both your regular light measurement and results in different control settings can be saved in the same file.

Results can be presented just as you wish in PDF reports or spreadsheets.

All of the wired control connections you can possibly dream of: LightInterface supports protocols DMX, DALI and 0-10V.

Just connect to your measurement PC with the free Viso Light Inspector software and you are good to go. (24V supply not necessary for normal use).